Hydrologic and Hydraulic Model Development for Flood Mitigation and Routing Method Comparison in Soap Creek Watershed, Iowa

Hydrologic and Hydraulic Model Development for Flood Mitigation and Routing Method Comparison in Soap Creek Watershed, Iowa

Author: Jingyun Sun

Publisher:

Published: 2015

Total Pages: 138

ISBN-13:

DOWNLOAD EBOOK

The primary objective of this thesis is to develop hydrologic and hydraulic models for the Soap Creek Watershed, IA for the evaluation of alternative flood mitigation strategies and the analysis of the differences between hydrologic and hydraulic routing methods. In 2008, the state of Iowa suffered a disastrous flood that caused extensive damage to homes, agricultural lands, commercial property, and public infrastructures. To reduce the flood damage across Iowa, the U.S. Department of Housing and Urban Development (HUD) awarded funds to the Iowa Flood Center and IIHR-Hydroscience &Engineering at the University of Iowa to conduct the Iowa Watersheds Project. The Soap Creek Watershed was selected as one of the study areas because this region has suffered frequent severe floods over the past century and because local landowners have organized to construct over 130 flood detention ponds within it since 1985. As part of the Iowa Watersheds Project, we developed a hydrologic model using the U.S. Army Corps of Engineers0́9 (USACE) Hydrologic Center0́9s hydrologic Modeling System (HEC-HMS). We used the hydrologic model to evaluate the effectiveness of the existing flood mitigation structures with respect to discharge and to identify the high runoff potential areas. We also investigated the potential impact of two additional flood mitigation practices within the Soap Creek Watershed by utilizing the hydrologic model, which includes changing the land use and improving the soil quality. The HEC-HMS model simulated 24-hour design storms with different return periods, including 10, 25, 50, and 100 year. The results from modeling four design storms revealed that all three practices can reduce the peak discharge at different levels. The existing detention ponds were shown to reduce the peak discharge by 28% to 40% depending on the choice of observed locations and design storms. However, changing the land use can reduce the peak discharge by an average of only 1.0 %, whereas improving the soil quality can result in an average of 15 % reduction. Additionally, we designed a hydraulic model using the United States Army Corps of Engineers0́9 (USACE) Hydrologic Engineering Center0́9s River Analysis System (HEC- RAS) to perform a comparative evaluation of hydrologic and hydraulic routing methods. The hydrologic routing method employed in this study is the Muskingum Routing method. We compare the historical and design storms between HEC-HMS, HEC-RAS, and observed stage hydrographs and take the hydrograph timing, shape, and magnitude into account. Our results indicate that the hydraulic routing method simulates the hydrograph shape more effectively in this case.


Flood Mitigation Planning Using HEC-SAM

Flood Mitigation Planning Using HEC-SAM

Author: Darryl W. Davis

Publisher:

Published: 1980

Total Pages: 26

ISBN-13:

DOWNLOAD EBOOK

Flood control and flood plain management investigations using spatial data management techniques are increasing in the Corps of Engineers. Pilot studies initiated in the mid-1970's were successful in consolidating analysis concepts, fostering the development of spatial data file creation and management technology and enhancing the consideration of existing and alternative future development patterns in Corps' planning studies. Over 30 studies using HEC-SAM, the Corps' spatial data management system, are now completed or underway. HEC-SAM was created through selective acquisition of commercial software, adaption of academic research products, and development by researchers at the Corps' Hydrologic Engineering Center (HEC). The HEC role continues to be that of system developer and technology transfer agent. The evolution, present capabilities, and applications of HEC-SAM are described. Observations are offered on spatial technology development, implementation, and servicing. (Author).


Watershed Models

Watershed Models

Author: Vijay P. Singh

Publisher: CRC Press

Published: 2010-09-28

Total Pages: 678

ISBN-13: 1420037439

DOWNLOAD EBOOK

Watershed modeling is at the heart of modern hydrology, supplying rich information that is vital to addressing resource planning, environmental, and social problems. Even in light of this important role, many books relegate the subject to a single chapter while books devoted to modeling focus only on a specific area of application. Recognizing the


Corps of Engineers' Experience with Automatic Calibration of a Precipitation-runoff Model

Corps of Engineers' Experience with Automatic Calibration of a Precipitation-runoff Model

Author: David T. Ford

Publisher:

Published: 1980

Total Pages: 20

ISBN-13:

DOWNLOAD EBOOK

Computer program HEC-1, a precipitation-runoff model widely used throughout the United States, includes the capability to estimate automatically any of twelve parameters necessary to model the precipitation-runoff process and the channel routing process. The parameter estimation scheme employs Newton's method to minimize a weighted sum of squares of differences between observed and computed hydrograph values. Applications of this parameter estimation procedure are presneted, and typical steps of the procedure for deterimining optimal parameter estimates are outlined. Recent efforts to improve the estimation algorithm and recent use of the calibration capability to update sequentially parameter estimates in a flood forecasting application are discussed. (Author).


Assessment of Flood Mitigation Strategies for Reducing Peak Discharges in the Upper Cedar River Watershed

Assessment of Flood Mitigation Strategies for Reducing Peak Discharges in the Upper Cedar River Watershed

Author: Chad Walter Drake

Publisher:

Published: 2014

Total Pages: 213

ISBN-13:

DOWNLOAD EBOOK

This thesis evaluates the effectiveness of several flood mitigation strategies for reducing peak discharges in the Upper Cedar River Watershed located in northeast Iowa. Triggered by record flooding in June 2008, the Iowa Watersheds Project was formed to evaluate and construct projects for flood reduction. The Upper Cedar was selected as a pilot watershed and a hydrologic assessment was performed to better understand its flood hydrology. Evaluation of different flood mitigation strategies was performed with HEC-HMS, a lumped parameter surface water model. The hydrologic model development is described and the model applications are analyzed. The HMS model was used in several ways to better understand the flood hydrology of the Upper Cedar River Watershed. First, the runoff potential of the basin was assessed to identify the primary runoff generation mechanisms. Areas with agricultural land use and moderately to poorly draining soils had the highest runoff potential. Following, the model was used to evaluate the impact of several flood mitigation strategies - increased infiltration through land use changes, increased infiltration through soil improvements, and added storage in the watershed to hold runoff temporarily and reduce downstream flood peaks - for different flood frequency events (the 10-, 25-, 50-, and 100-year, 24-hour design rain storms) and the June 2008 flood. Although each scenario is hypothetical and simplified, they do provide benchmarks for the types of reductions physically possible and the effectiveness of strategies relative to one another. In order to reduce the impacts of flooding in the Upper Cedar, a combination of projects that enhance infiltration and/or store excess runoff will be necessary.


A Hydraulic Flood Routing Model of the Peace River, Hudson Hope to Peace Point

A Hydraulic Flood Routing Model of the Peace River, Hudson Hope to Peace Point

Author: Faye Ellen Hicks

Publisher:

Published: 1996

Total Pages: 42

ISBN-13:

DOWNLOAD EBOOK

Describes a hydraulic flood routing model developed to accurately model the open water river discharge of moderate floods. The model is capable of modelling the open water discharge at intermediate sites along the Peace River where no discharge data exist. The final geometric model consists of over 1,100 computational nodes describing channel width, effective bed elevation, and channel roughness. The hydraulic flood routing model used was the cdg-1D finite element model developed at the University of Alberta. The model provides for a solution of the fully dynamic, one-dimensional open channel flow equations. In its first stage, the model covers the Peace River from Hudson's Hope to Peace Point; subsequent work will focus on extending the model to the Slave River delta and collecting additional cross- section data on the Peace River.