An Analysis of the Stability and Control Characteristics of an Ejector Wing V/STOL During Transition

An Analysis of the Stability and Control Characteristics of an Ejector Wing V/STOL During Transition

Author: George Kurylowich

Publisher:

Published: 1973

Total Pages: 212

ISBN-13:

DOWNLOAD EBOOK

An analysis was performed to investigate the longitudinal stability and control characteristics of an ejector wing configuration V/STOL in transition. A derivative approach was used to obtain dynamic responses about specified trim speeds, and analysis of these responses provided an insight into the significant characteristics that might affect the pilot's control over the aircraft. The thrust levels necessary to meet the control requirements specified in MIL-F-83300 for a Level 1 category vehicle were determined as well. A similar study was made for a stowable rotor configuration, and results for the stowable rotor V/STOL and the ejector wing configuration were compared. Finally, the downwash characteristics of the ejector wing configuration were evaluated in terms of their effect on ground equipment and personnel. Spray generation during hover over water is also discussed.


An Analytical Study of V/STOL Handling Qualities in Hover and Transition

An Analytical Study of V/STOL Handling Qualities in Hover and Transition

Author: R. L. Stapleford

Publisher:

Published: 1965

Total Pages: 174

ISBN-13:

DOWNLOAD EBOOK

The hover analysis considers pilot attitude and position control tasks in the presence of horizontal gusts. The effects of each of the stability derivatives on the difficulty of the control tasks and on the closed-loop gust responses are determined. It is clearly shown that the handling qualities studies of control sensitivity and angular damping must consider the influences of M sub u (or L sub v) and should include gust inputs. These conclusions are substantiated by previous variable-stability-helicopter experiments. The effects of vehicle size and geometry are investigated by several approaches. The key result of increasing size is found to be a reduction in M sub u and L sub v which can, in turn, lower the requirements for control power and damping. The handling qualities during transition of two vehicles, a tilt duct and a tilt wing, which were previously tested on a simulator are analyzed. It is shown that both trim control and perturbations about the trim conditions must be considered. In fact, part of the increased difficulty in landing transitions, in comparison with takeoff transitions, is due to more difficult trim control; the much more stringent position control requirements in landing are also a contributing factor.