Across the United States, thousands of hazardous waste sites are contaminated with chemicals that prevent the underlying groundwater from meeting drinking water standards. These include Superfund sites and other facilities that handle and dispose of hazardous waste, active and inactive dry cleaners, and leaking underground storage tanks; many are at federal facilities such as military installations. While many sites have been closed over the past 30 years through cleanup programs run by the U.S. Department of Defense, the U.S. EPA, and other state and federal agencies, the remaining caseload is much more difficult to address because the nature of the contamination and subsurface conditions make it difficult to achieve drinking water standards in the affected groundwater. Alternatives for Managing the Nation's Complex Contaminated Groundwater Sites estimates that at least 126,000 sites across the U.S. still have contaminated groundwater, and their closure is expected to cost at least $110 billion to $127 billion. About 10 percent of these sites are considered "complex," meaning restoration is unlikely to be achieved in the next 50 to 100 years due to technological limitations. At sites where contaminant concentrations have plateaued at levels above cleanup goals despite active efforts, the report recommends evaluating whether the sites should transition to long-term management, where risks would be monitored and harmful exposures prevented, but at reduced costs.
Because of the limitations of conventional pump-and-treat systems in treating groundwater contaminants, permeable barriers are potentially more cost-effective than pump-and-treat systems for treating dissolved chlorinated solvent plumes, which may persist in the saturated zone for several decades. Other contaminants, such as chromium or other soluble heavy metals, can also be treated with this technology. Permeable Barriers for Groundwater Remediation discusses the types of permeable barriers, their design and construction, and how they can be monitored to evaluate compliance. It provides practical guidance on reactive media selection, treatability testing, hydrogeologic and geochemical modeling, and innovative installation techniques for the evaluation and application of this promising new technology. The types of permeable barriers discussed include: trench-type and caisson-based reactive cells; innovative emplacements, such as horizontal trenching and jetting; and continuous reactive barriers versus funnel-and-gate systems.
V.3 ... consists of individual chapters that describe 1) the conceptual background for radionuclides, including tritium, radon, strontium, technetium, uranium, iodine, radium, thorium, cesium, plutonium-americium and 2) data requirements to be met during site characterization.
Fractured rock is the host or foundation for innumerable engineered structures related to energy, water, waste, and transportation. Characterizing, modeling, and monitoring fractured rock sites is critical to the functioning of those infrastructure, as well as to optimizing resource recovery and contaminant management. Characterization, Modeling, Monitoring, and Remediation of Fractured Rock examines the state of practice and state of art in the characterization of fractured rock and the chemical and biological processes related to subsurface contaminant fate and transport. This report examines new developments, knowledge, and approaches to engineering at fractured rock sites since the publication of the 1996 National Research Council report Rock Fractures and Fluid Flow: Contemporary Understanding and Fluid Flow. Fundamental understanding of the physical nature of fractured rock has changed little since 1996, but many new characterization tools have been developed, and there is now greater appreciation for the importance of chemical and biological processes that can occur in the fractured rock environment. The findings of Characterization, Modeling, Monitoring, and Remediation of Fractured Rock can be applied to all types of engineered infrastructure, but especially to engineered repositories for buried or stored waste and to fractured rock sites that have been contaminated as a result of past disposal or other practices. The recommendations of this report are intended to help the practitioner, researcher, and decision maker take a more interdisciplinary approach to engineering in the fractured rock environment. This report describes how existing tools-some only recently developed-can be used to increase the accuracy and reliability of engineering design and management given the interacting forces of nature. With an interdisciplinary approach, it is possible to conceptualize and model the fractured rock environment with acceptable levels of uncertainty and reliability, and to design systems that maximize remediation and long-term performance. Better scientific understanding could inform regulations, policies, and implementation guidelines related to infrastructure development and operations. The recommendations for research and applications to enhance practice of this book make it a valuable resource for students and practitioners in this field.
At hundreds of thousands of commercial, industrial, and military sites across the country, subsurface materials including groundwater are contaminated with chemical waste. The last decade has seen growing interest in using aggressive source remediation technologies to remove contaminants from the subsurface, but there is limited understanding of (1) the effectiveness of these technologies and (2) the overall effect of mass removal on groundwater quality. This report reviews the suite of technologies available for source remediation and their ability to reach a variety of cleanup goals, from meeting regulatory standards for groundwater to reducing costs. The report proposes elements of a protocol for accomplishing source remediation that should enable project managers to decide whether and how to pursue source remediation at their sites.
PFAS (per and polyfluoroalkylsubstances) are known to be extremely difficult to degrade in the environment and to be bioaccumulative and toxic. Exposure to PFAS is suspected to increase the risk of adverse health effects, such as impacts on the thyroid gland, the liver, fat metabolism and the immune system. This study estimates the socioeconomic costs that may result from impacts on human health and the environment from the use of PFAS. Better awareness of the costs and problems associated with PFAS exposure will assist decision-makers and the general public to make more efficient and timely risk management decisions. Findings indicate that the costs are substantial, with annual health-related costs estimated to 2.8 – 4.6 billion EUR for the Nordic countries and 52 – 84 billion EUR for all EEA countries. Overall non-health costs are estimated at 46 million – 11 billion EUR for the Nordic countries.Upon request the excel spreadsheets used for the monetarisation and valuation in this report can also be provided along with a guidance on how to use the estimation of costs for value transfer. Please contact any of the consultants or members of the steering group from the Swedish Chemicals Agency or the Danish Environmental Protection Agency if you are interested in receiving these excel spreadsheets.
Rapid and important developments in the area of energy - water nexus over the last two to three years have been significant. This new edition of Water and Energy: Threats and Opportunities is timely and continues to highlight the inextricable link between water and energy, providing an up-to-date overview of the subject with helpful detailed summaries of the technical literature. Water and Energy has been up-dated throughout and major changes are: new chapters on global warming and fossil fuels, including shale gas and fracking; the consequences of the Deepwater Horizon accident in the Mexican Gulf and the Niger Delta oil spills; new developments in hydropower; and continued competition between food, water and energy. Water and Energy Threats and Opportunities, 2e creates an awareness of the important couplings between water and energy. It shows how energy is used in all the various water cycle operations and demonstrates how water is used and misused in all kinds of energy production and generation.Population increase, climate change and an increasing competition between food and fuel production create enormous pressures on both water and energy availability. Since there is no replacement for water, water security looks more crucial than energy security. This is true not only in developing countries but also in the most advanced countries. For example, the western parts of the USA suffer from water scarcity that provides a real security threat. Part One of the book describes the water-energy nexus, the conflicts and competitions and the couplings between water security, energy security, and food security. Part Two captures how climate change, population increase and the growing food demand will have major impact on water availability in many countries in the world. Part Three describes water for energy and how energy production and conversion depend on water availability. As a consequence, all planning has to take both water and energy into consideration. The environmental (including water) consequences of oil and coal exploration and refining are huge, in North America as well as in the rest of the world. Furthermore, oil leak accidents have hit America, Africa, Europe as well as Asia. The consequences of hydropower are discussed and the competition between hydropower generation, flood control and water storage is illustrated. The importance of water for cooling thermal power plants is described, as this was so tragically demonstrated at the Fukushima nuclear plants in 2011. Climate change will further emphasize the strong coupling between water availability and the operation of power plants. Part Four analyses energy for water - how water production and treatment depend on energy. The book shows that a lot can be done to improve equipment, develop processes and apply advanced monitoring and control to save energy for water operations. Significant amounts of energy can be saved by better pumping, the reduction of leakages, controlled aeration in biological wastewater treatment, more efficient biogas production, and by improved desalination processes. There are 3 PowerPoint presentations available for Water and Energy - threats and opportunities, 2e. About the author Gustaf Olsson, Professor Em. in Industrial Automation, Lund University, Sweden Since 2006, Gustaf has been Professor Emeritus at Lund University, Sweden. Gustaf has devoted his research to control and automation in water systems, electrical power systems and process industries. From 2006 to 2008 he was part time professor in electrical power systems at Chalmers University of Technology, Sweden. He is guest professor at the Technical University of Malaysia (UTM) and at the Tsinghua University in Beijing, China and he is an honorary faculty member of the Exeter University in UK. Between 2005 and 2010 he was the editor-in-chief of the journals Water Science and Technology and Water Science and Technology/Water Supply, (IWA Publishing). From 2007 to 2010, he was a member of the IWA Board of Directors and in 2010 he received the IWA Publication Award. In 2012 he was the awardee of an Honorary Doctor degree at UTM and an Honorary Membership of IWA. Gustaf has guided 23 PhDs and a few hundred MSc students through their exams and has received the Lund University pedagogical award for distinguished achievements in the education". The Lund University engineering students elected him as the teacher of the year He has spent extended periods as a guest professor and visiting researcher at universities and companies in the USA, Australia and Japan and has been invited as a guest lecturer in 19 countries outside Sweden. He has authored nine books published in English, Russian, German and Chinese and and contributed with chapters in another 19 books as well as more than 170 scientific publications.
