Construction of a Thin-bonded Portland Cement Concrete Overlay Using Accelerated Paving Techniques

Construction of a Thin-bonded Portland Cement Concrete Overlay Using Accelerated Paving Techniques

Author: Kenneth H. McGhee

Publisher:

Published: 1992

Total Pages: 32

ISBN-13:

DOWNLOAD EBOOK

The report describes the Virginia Department of Transportations' first modern experience with the construction of thin-bonded Portland cement concrete overlays of existing concrete pavements and with the fast track mode of rigid paving. The study was conducted in cooperation with the Federal Highway Administration (FHWA) and used a paving mixture verified in an FHWA mobile laboratory. The study showed that the fast track mode will permit lane closure times as short as 48 hours. Of special interest was the finding that adequate strength of the bond between the old pavement and the overlay is not dependent on the use of a bonding grout.


Concrete Pavement Restoration (CPR) for Bonded Concrete Overlay of Asphalt (BCOA)

Concrete Pavement Restoration (CPR) for Bonded Concrete Overlay of Asphalt (BCOA)

Author: Andrea Blanchette

Publisher:

Published: 2020

Total Pages: 54

ISBN-13:

DOWNLOAD EBOOK

Bonded concrete overlay of asphalt (BCOA) pavements, also known as whitetopping, can help enhance the structural capacity and rideability of existing asphalt pavement. In this report, the generic term “BCOA” is used to describe all overlays that are between 3-inches and 7-inches thick and placed on an asphalt layer a minimum of 3-inches thick. BCOA is typically designed for a 20-year design life. Rehab should be considered when the distresses in a BCOA are causing ride quality issues or the panels have deteriorating cracks. Agencies have generally utilized concrete pavement restoration (CPR) techniques used for standard concrete pavements on grade to repair such overlays.However, these techniques may or may not be the appropriate repairs to address similar distresses in BCOA pavements. Over the past decade, the popularity of BCOA pavements has grown in many states and many of these projects are now reaching an age where rehab is needed. This has prompted the National Road Research Alliance (NRRA) to compile a synthesis of current practices of repairs being used on BCOA projects by the contributing state agencies. The most common type of repair of a BCOA pavement is to conduct a full-depth removaland replacement of the concrete panels when the area of distresses is localized. The main supporting factor is the BCOA pavement hassuch a thin overlay that it is more cost effective to perform this type of rehabilitation method as compared to the others.


Portland Cement Concrete Overlays

Portland Cement Concrete Overlays

Author: Kurt D. Smith

Publisher:

Published: 2002

Total Pages: 200

ISBN-13:

DOWNLOAD EBOOK

This report presents the latest information on the design, construction and performance of portland cement concrete (PCC) overlays. It describes the four types of PCC overlays that are commonly used in highway pavement applications: bonded PCC overlays, unbonded PCC overlays, conventional whitetopping and ultra-thin whitetopping. Recommended applications, critical design elements, current overlay design methodologies, recommended construction practices, and performance highlights are described for each overlay type. Information is also provided on the selection of PCC overlays as possible rehabilitation alternatives for existing pavements. Taken together, this document addresses the current "state of the technology" of PCC overlays placed on both existing PCC pavements and on existing hot-mix asphalt pavements.


Evaluation of a Thin-bonded Portland Cement Concrete Pavement Overlay

Evaluation of a Thin-bonded Portland Cement Concrete Pavement Overlay

Author: Thomas Elliott Freeman

Publisher:

Published: 1996

Total Pages: 16

ISBN-13:

DOWNLOAD EBOOK

This report discusses the performance of the Virginia Department of Transportation's first modern rehabilitation project involving a thin-bonded portland cement concrete overlay of an existing jointed concrete pavement. The performance of the rigid overlay, which was constructed in a fast-track mode to minimize lane closure time, was evaluated by detailed condition surveys conducted annually throughout a 6-year analysis period to identify, document, and monitor the occurrence of distress. The roughness of the overlay was also measured annually with an accelerometer-based inertial road profiler to permit an examination of the effects of surface deterioration on ride quality. After 6 full years of service, which included only minimal maintenance, the pavement overlay remained in good overall condition. Although the ride quality of the overlay remained virtually unchanged throughout the period, a significant increase in the occurrence of low-to-moderate-severity joint spalls, corner breaks, and to a lesser extent transverse cracks was noted during the fifth and sixth years. The extrusion of compression seals and the subsequent infiltration of water into the pavement structure probably contributed to the observed localized failure of the overlay/substrate bond in the vicinity of joints. This condition, in turn, weakened the pavement's structural capacity at panel edges and thereby resulted in the formation of corner breaks and cracks parallel with and near transverse joints. The consideration of thin-bonded concrete overlays constructed in a fast-track mode is recommended as a viable rehabilitation alternative for jointed concrete pavements that are not severely distressed. However, careful attention to joint installation and, in particular, joint maintenance is recommended for similar future rehabilitation projects.


Performance of Nongrouted Thin Bonded P.C.C. Overlays

Performance of Nongrouted Thin Bonded P.C.C. Overlays

Author: Mark K. Kaler

Publisher:

Published: 1986

Total Pages: 20

ISBN-13:

DOWNLOAD EBOOK

The Iowa road system has approximately 13,000 miles of Portland Cement Concrete Pavements, many of which are reaching the stage where major rehabilitation is required. Age, greater than anticipated traffic, heavier loads and deterioration related to coarse aggregate in the original pavement are some of the reasons that these pavements have reached this level of distress. One method utilized to rehabilitate distressed or underdesigned PCC pavements is the thin bonded Portland Cement Concrete overlay. Since the introduction of thin bonded overlays on highway pavements in 1973, the concrete paving industry has made progress in reducing the construction costs of this rehabilitation technique. With the advent of the shotblast machine, surface preparation costs have decreased from over $4.00 per square yard to most recently $1.42 per square yard. Other construction costs, including placement, grouting and sawing, have also declined. With each project, knowledge and efficiency have improved.