This 1958 book was primarily written to provide information on torsional vibration for the design and development departments of engineering companies, although it was also intended to serve students of the subject. It will be of value to anyone with an interest in torsional vibration and the development of engineering practice.
The Optic Assembly Building (OAB) is a facility where large optical mirror units are assembled and installed into Line Replaceable Units (LRUs) for deployment into the National Ignition Facility (NIF) laser system. The New Optics Insertion Device (NOID) is a powered jib crane specially designed to handle large optical assemblies. The NOID arm has three degrees of freedom. it can rotate about the vertical boom, travel up and down the boom, and extend away from and retract in towards the boom. The NOID is used to assist in the assembly of five types of Laser Mirror (LM) LRUs. These five LMs have been creatively named, LM4, LM5, LM6, LM7, and LM8. The LM4 and LM5 LRUs each contain four Mirror Sub-Assemblies (MSAs). The LM6, LM7, and LM8 LRUs each contain 2 MSAs. The MSAs are assembled apart from the LRU and are then installed in the LRU at the LM4-8 workstations. An MSA NOID End-Effector is required to interface with the MSAs and install them into the LRUs. The End-Effector must attach to the robo-hand on the end of the NOID arm. At the time the MSA NOID End-Effector was being designed the NOID, the LM4-5 workstation, and the LM6-8 workstation were already installed in the OAB. The LRUs and the MSAs designs were also complete. The MSA NOID End-Effector design had to work with the assembly equipment and LRU designs that were already in place.
