Analog Signal Generation for Built-In-Self-Test (BIST) of Mixed-Signal Integrated Circuits is a concise introduction to a powerful new signal generation technique. The book begins with a brief introduction to the testing problem and a review of conventional signal generation techniques. The book then describes an oversampling-based oscillator capable of generating high-precision analog tones using a combination of digital logic and D/A conversion. These concepts are then extended to multi-tone testing schemes without introducing a severe hardware penalty. The concepts are extended further to encompass piece-wise linear waveforms such as square, triangular and sawtooth waves. Experimental results are presented to verify the ideas in each chapter and finally, conclusions are drawn. For those readers unfamiliar with delta-sigma modulation techniques, a brief introduction to this subject is also provided in an appendix. The book is ideal for test engineers, researchers and circuits designers with an interest in IC testing methods.
Analog Signal Generation for Built-In-Self-Test (BIST) of Mixed-Signal Integrated Circuits is a concise introduction to a powerful new signal generation technique. The book begins with a brief introduction to the testing problem and a review of conventional signal generation techniques. The book then describes an oversampling-based oscillator capable of generating high-precision analog tones using a combination of digital logic and D/A conversion. These concepts are then extended to multi-tone testing schemes without introducing a severe hardware penalty. The concepts are extended further to encompass piece-wise linear waveforms such as square, triangular and sawtooth waves. Experimental results are presented to verify the ideas in each chapter and finally, conclusions are drawn. For those readers unfamiliar with delta-sigma modulation techniques, a brief introduction to this subject is also provided in an appendix. The book is ideal for test engineers, researchers and circuits designers with an interest in IC testing methods.
The modern electronic testing has a forty year history. Test professionals hold some fairly large conferences and numerous workshops, have a journal, and there are over one hundred books on testing. Still, a full course on testing is offered only at a few universities, mostly by professors who have a research interest in this area. Apparently, most professors would not have taken a course on electronic testing when they were students. Other than the computer engineering curriculum being too crowded, the major reason cited for the absence of a course on electronic testing is the lack of a suitable textbook. For VLSI the foundation was provided by semiconductor device techn- ogy, circuit design, and electronic testing. In a computer engineering curriculum, therefore, it is necessary that foundations should be taught before applications. The field of VLSI has expanded to systems-on-a-chip, which include digital, memory, and mixed-signalsubsystems. To our knowledge this is the first textbook to cover all three types of electronic circuits. We have written this textbook for an undergraduate “foundations” course on electronic testing. Obviously, it is too voluminous for a one-semester course and a teacher will have to select from the topics. We did not restrict such freedom because the selection may depend upon the individual expertise and interests. Besides, there is merit in having a larger book that will retain its usefulness for the owner even after the completion of the course. With equal tenacity, we address the needs of three other groups of readers.
More and more chips are being designed with both analog and digital circuitry next to each other, which makes testing analog circuitry even more challenging. This comprehensive guide reviews all the potential testing options, helping designers, engineers, CAD developers, and researchers choose the most cost-effective, accurate solutions for both mixed-signal and analog-only testing.
Enables the reader to test an analog circuit that is implemented either in bipolar or MOS technology. Examines the testing and fault diagnosis of analog and analog part of mixed signal circuits. Covers the testing and fault diagnosis of both bipolar and Metal Oxide Semiconductor (MOS) circuits and introduces . Also contains problems that can be used as quiz or homework.
The book presents the analysis and design of integrated automotive radar receivers in Silicon-Germanium technology, for use in complex multi-channel radar transceiver front-ends in the 77GHz frequency band. The main emphasis of the work is the realization of high-linearity and low-power modular receiver channels as well as the investigation of millimeter-wave integrated test concepts for the receiver front-end.
Using the book and the software provided with it, the reader can build his/her own tester arrangement to investigate key aspects of analog-, digital- and mixed system circuits Plan of attack based on traditional testing, circuit design and circuit manufacture allows the reader to appreciate a testing regime from the point of view of all the participating interests Worked examples based on theoretical bookwork, practical experimentation and simulation exercises teach the reader how to test circuits thoroughly and effectively
Test and Design-for-Testability in Mixed-Signal Integrated Circuits deals with test and design for test of analog and mixed-signal integrated circuits. Especially in System-on-Chip (SoC), where different technologies are intertwined (analog, digital, sensors, RF); test is becoming a true bottleneck of present and future IC projects. Linking design and test in these heterogeneous systems will have a tremendous impact in terms of test time, cost and proficiency. Although it is recognized as a key issue for developing complex ICs, there is still a lack of structured references presenting the major topics in this area. The aim of this book is to present basic concepts and new ideas in a manner understandable for both professionals and students. Since this is an active research field, a comprehensive state-of-the-art overview is very valuable, introducing the main problems as well as the ways of solution that seem promising, emphasizing their basis, strengths and weaknesses. In essence, several topics are presented in detail. First of all, techniques for the efficient use of DSP-based test and CAD test tools. Standardization is another topic considered in the book, with focus on the IEEE 1149.4. Also addressed in depth is the connecting design and test by means of using high-level (behavioural) description techniques, specific examples are given. Another issue is related to test techniques for well-defined classes of integrated blocks, like data converters and phase-locked-loops. Besides these specification-driven testing techniques, fault-driven approaches are described as they offer potential solutions which are more similar to digital test methods. Finally, in Design-for-Testability and Built-In-Self-Test, two other concepts that were taken from digital design, are introduced in an analog context and illustrated for the case of integrated filters. In summary, the purpose of this book is to provide a glimpse on recent research results in the area of testing mixed-signal integrated circuits, specifically in the topics mentioned above. Much of the work reported herein has been performed within cooperative European Research Projects, in which the authors of the different chapters have actively collaborated. It is a representative snapshot of the current state-of-the-art in this emergent field.
This book provides a comprehensive discussion of automatic testing, diagnosis and tuning of analogue, mixed-signal and RF integrated circuits, and systems in a single source. As well as fundamental concepts and techniques, the book reports systematically the state of the arts and future research directions of those areas. A complete range of circuit components are covered and test issues from the SoC perspective. An essential reference for researchers and engineers in mixed signal testing, postgraduate and senior undergraduate students.
This book contains a selection of tutorials on hot topics in information technology, which were presented at the IFIP World Computer Congress. WCC2004 took place at the Centre de Congrès Pierre Baudis, in Toulouse, France, from 22 to 27 August 2004. The 11 chapters included in the book were chosen from tutorials proposals submitted to WCC2004. These papers report on several important and state-of-the-art topics on information technology such as: Quality of Service in Information Networks Risk-Driven Development of Security-Critical Systems Using UMLsec Developing Portable Software Formal Reasoning About Systems, Software and Hardware Using Functionals, Predicates and Relations The Problematic of Distributed Systems Supervision Software Rejuvenation - Modeling and Analysis Test and Design-for-Test of Mixed-Signal Integrated Circuits Web Services Applications of Multi-Agent Systems Discrete Event Simulation Human-Centered Automation We hereby would like to thank IFIP and more specifically WCC2004 Tutorials Committee and the authors for their contribution. We also would like to thank the congress organizers who have done a great job. Ricardo Reis Editor QUALITY OF SERVICE IN INFORMATION NETWORKS Augusto Casaca IST/INESC, R. Alves Redol, 1000-029, Lisboa, Portugal. Abstract: This article introduces the problems concerned with the provision of end-- end quality of service in IP networks, which are the basis of information networks, describes the existing solutions for that provision and presents some of the current research items on the subject. Key words: Information networks, IP networks, Integrated Services, Differentiated Services, Multiprotocol Label Switching, UMTS.
