Safety Evaluation of Centerline Rumble Strips
Author: David A. Noyce
Publisher:
Published: 2003
Total Pages: 120
ISBN-13:
DOWNLOAD EBOOKRead and Download eBook Full
Author: David A. Noyce
Publisher:
Published: 2003
Total Pages: 120
ISBN-13:
DOWNLOAD EBOOKAuthor: Darren J. Torbic
Publisher: Transportation Research Board
Published: 2009
Total Pages: 284
ISBN-13: 0309117992
DOWNLOAD EBOOKThis report provides guidance for the design and application of shoulder and centerline rumble strips as an effective crash reduction measure, while minimizing adverse effects for motorcyclists, bicyclists, and nearby residents. Using the results of previous studies and the research conducted under this project, safety effectiveness estimates were developed for shoulder rumble strips on rural freeways and rural two-lane roads and for centerline rumble strips on rural and urban two-lane roads.
Author: Darren J. Torbic
Publisher: Transportation Research Board National Research
Published: 2009
Total Pages: 188
ISBN-13:
DOWNLOAD EBOOKThis report provides guidance for the design and application of shoulder and centerline rumble strips as an effective crash reduction measure, while minimizing adverse effects for motorcyclists, bicyclists, and nearby residents. Using the results of previous studies and the research conducted under this project, safety effectiveness estimates were developed for shoulder rumble strips on rural freeways and rural two-lane roads and for centerline rumble strips on rural and urban two-lane roads.
Author: Chung S. Chen
Publisher:
Published: 2005
Total Pages: 50
ISBN-13:
DOWNLOAD EBOOKFollowing the wide and successful use of continuous shoulder rumble strips, many state departments of transportations (DOTs) installed centerline rumble strips (CLRS) on rural two-lane and undivided multilane highways in an effort to reduce cross-over-the-centerline (COCL) crashes. COCL crashes include head-on, sideswipe opposite direction, fixed object run-off-the-road left, and non-collision. The purpose of this research was to develop guidelines for using CLRS in Virginia based on a review of best practices and the analysis of Virginia COCL crash data from 2001 through 2003. The analysis procedures included data query and analyses of crash frequency, density, and rate. Areas and route locations with the highest COCL crashes and densities were identified as potential candidate sites for CLRS. As of 2003, 24 state DOTs and two Canadian provinces were using CLRS. They are generally installed on a case-by-case basis. CLRS design patterns vary greatly among states, but the most commonly used types are continuous grooves 12 to 16 inches in length, 6 to 7 inches in width, and 0.5 inch in depth spaced 12 or 24 inches apart. The optimal CLRS patterns remain unknown. Data analyses revealed that the distribution of COCL crashes in Virginia varied significantly with roadway system, road type, jurisdictional area, and road location. The statewide COCL crash densities were 0.13 and 0.71 crash per mile for secondary and primary roads, respectively. Fixed object run-off-the-road left was the predominant type of COCL crash followed by sideswipe opposite direction and head-on for undivided roads. The crash density of the primary system was 4.5 times higher than that of the secondary system. Guidelines were developed that outline the application of CLRS, design dimensions, installation and maintenance, and other issues. The authors recommend that the Virginia Department of Transportation's Traffic Engineering Division implement the guidelines as a division memorandum. Although a benefit-cost ratio for this recommendation will vary with each site, a sample estimated benefit-cost ratio was at least 7.6 per mile.
Author:
Publisher:
Published: 2003
Total Pages: 50
ISBN-13:
DOWNLOAD EBOOKAuthor: Lee August Rodegerdts
Publisher: Transportation Research Board
Published: 2010
Total Pages: 407
ISBN-13: 0309155118
DOWNLOAD EBOOKTRB's National Cooperative Highway Research Program (NCHRP) Report 672: Roundabouts: An Informational Guide - Second Edition explores the planning, design, construction, maintenance, and operation of roundabouts. The report also addresses issues that may be useful in helping to explain the trade-offs associated with roundabouts. This report updates the U.S. Federal Highway Administration's Roundabouts: An Informational Guide, based on experience gained in the United States since that guide was published in 2000.
Author: John L. Campbell
Publisher: Transportation Research Board
Published: 2012
Total Pages: 319
ISBN-13: 0309258162
DOWNLOAD EBOOK"This report completes and updates the first edition of NCHRP Report 600: Human Factors Guidelines for Road Systems (HFG), which was published previously in three collections. The HFG contains guidelines that provide human factors principles and findings for consideration by, and is a resource document for, highway designers, traffic engineers, and other safety practitioners."--Foreword.
Author:
Publisher: Amer Assn of State Hwy
Published: 1996-01-01
Total Pages: 352
ISBN-13: 9781560510314
DOWNLOAD EBOOKThis document presents a synthesis of current information and operating practices related to roadside safety and is developed in metric units. The roadside is defined as that area beyond the traveled way (driving lanes) and the shoulder (if any) of the roadway itself. The focus of this guide is on safety treatments that minimize the likelihood of serious injuries when a driver runs off the road. This guide replaces the 1989 AASHTO "Roadside Design Guide."
Author: Michael J. Markow
Publisher: Transportation Research Board
Published: 2012
Total Pages: 127
ISBN-13: 0309223431
DOWNLOAD EBOOKTRB’s National Cooperative Highway Research Program (NCHRP) Synthesis 424: Engineering Economic Analysis Practices for Highway Investment explores how U.S. transportation agencies have applied engineering economics--benefit–cost analyses and similar procedures--to decisions on highway investments.