Development of High-temperature Strain Gages
Development of High-temperature Strain Gages

Author: J. W. Pitts

Publisher:

Published: 1961

Total Pages: 322

ISBN-13:

DOWNLOAD EBOOK

A summary is presented of a research program aimed at the improvement of high-temperature strain gages of the electrical resistance type. Potential ceramic and metal components were evaluated and a gage was devised that was based on these evaluations. This gage (NBS 5B) was flexible and easy to install; however, it lacked resistance stability at higher temperatures. In an attempt to minimize this deficiency, ceramic cements were developed that showed greater electrical resistivity than had been previously observed in the range 800 to 1800 degrees Fahrenheit; also, a technique was devised for increasing the resistance to ground by applying a fired-on ceramic coating to the grid of a specifically developed unbacked gage. A study was made of the cause of the erratic response of cemented gages that had not been preheated prior to use. There were strong indications that the erratic response was caused mostly by the rapid decrease in resistance that accompanied structural changes in the cement.

Manual on Experimental Methods for Mechanical Testing of Composites
Manual on Experimental Methods for Mechanical Testing of Composites

Author: R. Pendleton

Publisher: Springer Science & Business Media

Published: 2012-12-06

Total Pages: 175

ISBN-13: 9400911297

DOWNLOAD EBOOK

References Liquid-metal strain gages can be fabricated in either single- or delta-rosette configurations. Their main advantages are their low stiffness (essential for 1. Beatty, M.F. and Chewning, S. W., "Numerical Analysis of the Reinforcement Effect of a Strain Gage Applied to a Soft use on composites with soft, elastomeric matrices) Material," Int. J. Eng. Sci., 17, 907-915 (1979). and high elongation (at least 50 percent). Their prin 2. Pugin, V.A., "Electrical Strain Gauges for Measuring Large cipal disadvantages are a short shelf life and a Deformations," Soviet Rubber Industry, 19 (1), 23-26 (1960). nonlinear calibration curve. 3. Janssen, M.L. and Walter, J.D., "Rubber Strain Measurements in Bias, Belted Bias and Radial Ply Tires," J. Coated Fibrous Mat., 1, 102-117 (1971). 4. Patel, H.P., Turner, J.L., and Walter, J.D., "Radial Tire Cord-Rubber Composite," Rubber Chem. and Tech., 49, Acknowledgments 1095-1110 (1976). 5. Stone, J.E., Madsen, N.H., Milton, J.L., Swinson, W.F., and Turner, J.L., "Developments in the Design and Use of Liquid-Metal Strain Gages," EXPERIMENTAL MECHANICS, 23, The author acknowledges helpful suggestions by 129-139 (1983). Dr. Joseph D. Walter of Firestone Central Research 6. Whitney, R.J., "The Measurement of Volume Changes in Human Limbs, " J. Physiology, 121, 1-27 (1953).